Something I painted up.

Just wanted to show this off.  Its a Wight standard bearer for my wife's Vampire Counts.  The banner is hand painted.

I'll have a tutorial on how I did the banner at a later date.  Its actually very easy to do.

TTFN

Tip of the Month

A small tile (2”x2”) makes a perfect and easy-to-clean palette (you can get one as a free sample from a hardware store).  Use a razor blade or soap & water to clean it off.

Lest we forget.

Sci-Fi Hangers How-To (Part 1)

Hello Ladies and Gentlemen, Hobos and Tramps, Bug-eyed mosquitos and bow-legged Ants.

So I finally have some workspace to start up my scenery building again.  For my first project, its something easy that anyone can do in a couple of evenings.

On to the Sci-Fi Hangers:
The hangers are styrofoam packing inserts that I found somewhere.  Usually a piece of trash will have the right look for terrain if you look at it the right way.

First, measure the base boards for the hangers.  I use 1/8th MDF for all my bases since its light, doesn't warp as much when wet with glue, and you can cut it with a utility knife. (See "Making Terrain" for more.)  Place the building on top of the base and measure 1 1/2 inches from each side.  This gets you the proper dimensions for the base.  Figure 1/2" that will be cut off and an inch for the models to stand on.  Once you have the measurements, you can cut the base out.

All your base belong to us!

The base may look a little ragged at this point.  This is will be straightened out in the next step.  Take your utility knife and start to cut or shave the edges down to a 45 degree angle (it doesn't have to be exact).  You'll know you're doing it right when the edge comes to a crisp point.  SAFETY POINT: Always cut away from you!


Still a little rough but almost there.

 Now that you have the shape you want, sand it down with a medium grit sandpaper (100 grit is fine) to get the rough edges off.  This will also round the corners so it won't be too square.  I usually round all my bases except for the ones used for city terrain.  The square bases automatically become curbs.  The round base blends better into the battleboard.  The slope also makes it easier for models to stand on without falling over.


The finished base.

Now that the base is smoothed down, place the building on top to check for fit.  You can make any adjustments in trimming if needed.


Yep, it fits.

In the next session, I'll show you how to detail the hangers and attach them to the bases.  Believe it or not, they're construction is already half way done.  I'm actually building two of them at the same time.